"Approaching Meihui" Vol. 9 | 3 Common Problems in Construction and Their Solutions
Release time:
2021-12-20
Source:
Q1Why do spots or color differences appear on the wall after the scaffolding is removed?
Analysis:
There are two main reasons for this issue: first, the middle coat is sprayed unevenly; second, the top coat is rolled unevenly. During construction, workers can only observe from a close distance due to the scaffolding's obstruction and insufficient light, making it difficult to notice problems. However, once the scaffolding is removed, the lack of obstruction and sufficient light will expose all issues.
Solution:
1. How to avoid this problem?
a. When spraying the middle coat, ensure uniformity and maintain a consistent spray pattern.
b. When rolling or spraying the top coat, pay attention to the joints to ensure they are uniform, avoiding severe re-coating, otherwise, uneven gloss will occur.
2. If the problem has already occurred, how to remedy it?
a. If the issue is simply the rolling pattern of the top coat, dilute the top coat with 20%-30% water and re-roll it; this will significantly reduce the issue.
b. If the problem is severe, or if the uneven spraying of the middle coat caused the issue, it is necessary to re-spray the middle coat according to standards before applying the top coat.

Q2Why is it easy to encounter clogging issues when spraying in winter?
Analysis:
The spray gun has diameters of 3.0 (recommended for flat stone-like paint) and 4.0 (recommended for coarse stone-like paint). Due to the larger particle size of coarse stone-like paint, we always specify using a 4.0 diameter spray gun for spraying it. However, during construction, there are instances where a 3.0 or 3.5 diameter spray gun is used for coarse stone-like paint, leading to clogging; this is the first reason. The second reason is that in winter, the low temperature significantly increases the viscosity of the materials, and if the air pressure is not controlled properly during spraying, clogging is likely to occur.
Solution:
1. How to avoid clogging? You can appropriately add 3%-5% water to dilute the middle coat, but be careful not to exceed 5%, otherwise, the particles will become mushy.
2. If clogging occurs, how to resolve it? We can use an air gun to blow air at the nozzle of the spray gun to clear the clog, which can quickly resolve the issue.

Q3What are the techniques for spraying water-based sand middle coat?
Construction techniques:
First, we need to be clear about what effect we want to achieve when spraying the middle coat. Some homeowners prefer a flatter effect, while others prefer a more textured effect.
1. If we want to spray a textured effect, we can slightly lower the air pressure during the first and second coats to allow the stone-like paint particles to be fuller and avoid being flattened.
2. If we want to spray a relatively flat effect with smaller particles, we can increase the air pressure during the first coat of the middle coat, but be careful not to break all the particles; during the second coat, spray at normal air pressure.
When spraying, we should maintain a distance of about 40-50cm between the gun and the wall for the best spraying effect; being too close will lead to uneven spraying, while being too far will result in material waste.

Meihui Stone Feel Paint, Construction Techniques
RELATED INFORMATION
FUJIAN HUIXING COATINGS TECHNOLOGY DEVELOPMENT CO., LTD
TEL /400-995-8827
Address: Quanhui Petrochemical Park, Fujian Province
Website: www.fjhuixing.cn
Subscribe to us
Enter your email address to register for new service notifications.
Page Copyright © 2024 Fujian Huixing Coating Technology Development Co., Ltd.