"Getting Close to Meihui" Vol. 4 | 4 Common Problems in Engineering, Can You Solve Them?
Release time:
2021-08-12
Source:
This issue is about common problems encountered by the technical service department teachers during project execution. Let's take a look together~
Q1


Q1: How to deal with cracking between the putty layer and aluminum alloy?
Analysis:The putty layer belongs to the mortar category, while aluminum alloy belongs to the metal category. The expansion and contraction ratios of the two are inconsistent. In exterior wall construction, coupled with inconsistent external temperature conditions, cracking is likely to occur. This is a common phenomenon.
Solution:
Method 1:
Currently, there is no good solution in the industry. More often, an interface is created on the aluminum alloy layer to increase adhesion, but this method cannot fundamentally solve the occurrence of this phenomenon; it should also be noted that spraying stone-like paint on the aluminum alloy layer generally has weak bonding strength between the metal and the coating, so an interface should be created on the aluminum alloy layer to increase adhesion. However, it is difficult to predict whether cracking will occur later and how long it will last.
Method 2:
To completely solve the cracking phenomenon between the putty layer and aluminum alloy, the foam tape process can be used for construction. The foam tape process should pay attention to:
a) Tape flatness;
b) Base surface flatness;
c) Leveling thickness control;
d) Coating technique in the groove.
Q2: After the putty is polished without water curing, and it rains for a month, how to handle it after the weather clears?
Solution:After the weather clears, first consider whether there is dust left on the wall from the rainwater on the putty layer. If so, the putty layer should be cleaned before further construction.
Q3: When making black lines, how to solve the problem of the dividing tape easily tearing off the black primer?
Analysis:The adhesive of the tape is stronger than the bonding degree of the exterior wall putty powder, causing the black paint and putty powder to be lifted together by the tape.
Solution:
1) Increase the strength of the putty; the standard construction process "putty water curing" must be done properly;
2) After the black paint is completely dry, then stick the tape for protection;
3) Use high-quality tape for construction.

Q4: The tape is easy to break, the adhesion increases, and it is difficult to tear off.
Analysis:After the stone-like paint middle coat is completely dry, the large amount of emulsion contained in the middle coat adheres to and penetrates the tape, which affects the tensile strength and adhesion of the tape.
Solution:After the middle coat spraying is completed, remove the tape directly after initial drying, under room temperature conditions: remove the tape about 30 minutes after the middle coat spraying.

Construction issues, solutions, Meihui Stone Feel Paint.
RELATED INFORMATION
FUJIAN HUIXING COATINGS TECHNOLOGY DEVELOPMENT CO., LTD
TEL /400-995-8827
Address: Quanhui Petrochemical Park, Fujian Province
Website: www.fjhuixing.cn
Subscribe to us
Enter your email address to register for new service notifications.
Page Copyright © 2024 Fujian Huixing Coating Technology Development Co., Ltd.